Automotive stamping parts need to meet the requirements of use and technical performance

2020-10-20 16:51:35

In the process of producing automobile stamping parts, it is easy to affect the service life of the die due to the raw materials, heat treatment of die materials, structure, use specification and maintenance frequency, thus affecting the quality of stamping products. Then, how can we reduce or avoid this in the production of automobile stamping parts?

1、 Automotive stamping products design needs to meet the requirements of use and technical performance, and facilitate the assembly of die.

2、 In the design of automobile stamping parts, it is necessary to adopt the scheme of improving material utilization rate and reducing material loss, so as to make stamping parts achieve zero waste or less waste.

3、 The design must meet the purpose of simple shape, reasonable structure, simple and practical process, avoid using other processing methods, which is conducive to stamping; the advantage is to use automatic stamping, improve production efficiency.

4、 In the production of automobile stamping parts, the existing equipment and process flow should be used as much as possible to prolong the life of stamping die.

The engine timing belt and drive belt should be inspected or replaced at 60000 km. If the vehicle is equipped with timing chain, it is not necessary to replace it under the constraint of "60000 km".

In order to ensure the cleanness of the oil circuit, the engine is equipped with an oil filter in the lubrication system. In order to prevent impurities from mixing into the oil to cause oxidation and produce gum and sludge to block the oil circuit. The oil filter should be changed at the same time after driving 5000 km.