How to deal with the theft of auto parts in the community?

2019-12-04 09:22:35

The car is parked in the parking space of its own community. Although the ground lock is installed, it cannot prevent the theft of vehicle parts. This makes a lot of car owners feel helpless in spite of their anger. How to deal with the theft of auto parts in the community?

Many car owners buy cars, in addition to the car insurance, but also some additional insurance. The common one is vehicle theft, because this kind of insurance can compensate for vehicle theft. The insurance liability is the reasonable cost of vehicle loss caused by theft, robbery and snatch of the whole vehicle, as well as the damage during theft, robbery and snatch or the loss of parts and accessories on the vehicle that need to be repaired.

But at the same time, we should also know that the compensation for vehicle theft and rescue is not 100%, it also needs to be determined according to the actual situation, and many car owners can not even get compensation. The scope of the theft and rescue shall include the parts and components of the whole vehicle, tires, doors, lights, etc. In fact, the probability of stealing the whole vehicle is lower than that of stealing the parts of the vehicle. The explanation that the insurance company only compensates for the theft of the whole vehicle is untenable. This kind of clause is unfair.

The insurance law is formulated to ensure the reasonable and orderly development of the insurance industry, and to strengthen the protection of the interests of the insured, that is, consumers. The current scope of claims for theft and rescue is obviously contrary to this spirit.

After the car sheet metal parts are taken for repair or repair, the next process is very important, that is, cleaning, do a good job of cleaning, and the car body is completely new. So how to clean it?

(1) cleaning and assembly.

The repairman must remove welding slag and adhesive residue, and then clean the body surface. Especially for bare metal surface, it is necessary to spray anti-corrosion materials on it. After body repair work, assembly is required. The finished body and local accessories, parts to be replaced and disassembled parts shall be assembled according to the requirements of the original vehicle.

(2) four wheel alignment.

The vehicle shall be debugged or tested, and the four-wheel positioning shall be carried out for the vehicle with serious collision. To do four-wheel alignment is to check whether the inclination angle and toe value of each wheel of the vehicle meet the original factory standard through the four-wheel alignment instrument. If not, it can be adjusted randomly. Only when the vehicle's positioning data is accurate, can the vehicle's handling performance and stability reach a good state, and the tire's service life also reach a long time. Through the four-wheel alignment inspection, if some data are found not to meet the specified standards, it is necessary to debug until all parameters are within the standard range. The supervisor should check the quality of the repair and then transfer the body to painting.

(3) cleaning methods.

① the inner ceiling shall be cleaned carefully. The cleaning method is usually to use high-power vacuum tube and brush to clean large area first, then use neutral detergent to clean the dirt, and then conduct comprehensive cleaning.

② the specific cleaning method is to first use a high-power vacuum cleaner, and at the same time cooperate with the ceiling soft brush for preliminary cleaning. Then spray the neutral foam cleanser onto the top of the suede. The general quality foam cleaner will hang on the top for a long time. After a few minutes, use the special clean soft brush of the ceiling to gently wash, and then use the wet towel to wipe it.

Do not use any other bristle brush, otherwise it will easily make the fluff fall off. Use the foam cleanser on the suede ceiling, but you must buy the right kind of fabric. Then vacuum it. For stubborn stains, it is necessary to repeatedly spray foam to scrub, clean it and clean it with another clean cotton cloth along the direction of the top of the roof so as to restore its original appearance.