What are the Inspection Methods for Stamping Parts of Automotive Parts?

2019-07-05 15:15:43

The testing methods for stamping parts of automotive parts are as follows:

Touch test: wipe the surface of the outer covering with clean gauze. Inspectors need to wear touch gloves to touch along the stamping part vertically close to the surface of the stamping part. This inspection method depends on the experience of the inspectors. If necessary, the suspicious area can be polished and verified by oil stone, but this method is an effective and rapid inspection method.

Oilstone polishing: 1. First, clean the surface of the outer covering with clean gauze, then polish with oil stone, where there are arcs and where it is difficult to touch, polish with relatively small oil stone 2. The choice of the size of oil stone depends on the surface condition. Fine-grained oilstone is recommended. The direction of polishing is basically along the longitudinal direction, and it fits well to the surface of stamping parts. Some special places can also be supplemented by horizontal polishing.

Flexible yarn grinding: clean the surface of the outer covering with clean gauze. The surface of stamping parts is polished vertically with flexible sand mesh to the whole surface, and any pitting and indentation can be easily found.

4. Oil test: wipe the surface of the outer covering with clean gauze. Then use a clean brush to uniformly apply oil in the same direction to the entire outer surface of the stamping part. Put the finished oil stamping parts under strong light for inspection, and it is suggested that the stamping parts be erected on the body position. With this method, it is easy to find tiny pits, hollows and ripples on stamping parts.

Visual inspection; Visual inspection is mainly used to find abnormal appearance and macro defects of stamping parts.

Inspection of checking fixture: Put stamping parts into checking fixture, and inspect stamping parts according to operating requirements of checking fixture instructions.

Production safety problems: In actual production, process tests similar to stamping process, such as drawing performance test and bulging performance test, are commonly used to test the stamping performance of materials, so as to ensure the quality of finished products and high qualified rate.