What should we pay attention to when processing automobile stamping parts?

2020-06-02 10:22:50

Automobile stamping parts are processed by punch. In the whole process, the operation of lathe equipment is very critical. If not properly grasped, it will not only affect the forming quality of stamping parts, but also the equipment may be damaged. The key is that the safety of staff can not be guaranteed. Therefore, the operation requirements of lathe equipment for stamping parts processing will be brought to you soon.

First of all, when the lathe is punching, the operator must take corresponding protective measures; at the same time, the equipment must be checked comprehensively, including the stability of each part, the working condition of the lathe, the installation accuracy of parts, etc. If any problem is found during the inspection, it shall be handled in time to avoid more serious consequences.

In addition, in the manufacturing process of stamping parts, in addition to the need to install active measurement equipment in the lathe, all the work pieces should be stopped for measurement to ensure safety. All of the above mentioned points need attention during processing and are for your safety.

If we carefully observe the automobile stamping parts, we will find that the surface of the products has concave and convex, which affects the quality of the whole workpiece. To improve this situation, we must first find the root cause of the problem, and then formulate relevant solutions. Stamping parts manufacturers have realized the seriousness of this problem, so they have started to improve.

For the concave and convex of the stamping metal surface, most of them are caused by the impurities attached to the raw materials or stamping dies; or in the stamping process, the automobile parts and dies are collided; the height of the raw material conveyor belt is not reasonably adjusted; the deformation of the working tools and so on. All of the above mentioned problems may cause deformation and concave convex of stamping parts.

In addition to individual reasons, it will also make the stamping parts deformed. These concave and convex stamping parts need to be treated differently and can not be applied to automobile parts. If it is possible to repair, it should be repaired in time. If the deformation is serious, it can only be discarded.